Check Operation - Kohler K-77780 Guia De Instalacion

Push to
flush.

8. Check Operation

CAUTION: Risk of personal injury. Make sure the plug (if plug-in connection is used) and
receptacle are dry. If any moisture is present, allow the area to dry before plugging the unit in.
NOTE: The flushing mechanism works best if it is quickly tapped, not held down for an extended period
of time.
Plug the power cord into the GFCI- or RCD- protected receptacle.
Flush the toilet and check for proper operation by pushing the manual flush actuator.
Refer to the troubleshooting table in the Homeowners Guide if the toilet does not function
properly.
9. Secure the Vitreous Shell
CAUTION: Risk of product damage. Do not overtighten the screws when tightening. The vitreous shell
may chip or break if the screws are overtightened.
Insert a screw through each grommet.
Insert a screw in each of the holes on the side of the vitreous shell and tighten securely. Do not
overtighten.
Install a cap over each screw. The caps should be flush with the exterior of the shell.
1288209-2-A
Grommet
Screw
Cap
12 Kohler Co.