Check The Installation - Kohler Quiet-Close K-8298-CR-0 C3-455 Instrucciones De Instalación

7. Check the Installation

NOTE: Covering the seat with plastic wrap is optional. The features can be tested while sitting on the seat or covering the
wand with your hand.
NOTE: When testing the features, apply pressure to the occupancy sensor on the right side of the seat (facing the toilet).
The features will not activate if there is no pressure on the sensor.
Optional: Wrap the seat with plastic wrap to prevent water from spraying beyond the toilet while testing.
Plug the power cord into the electrical outlet. The seat will go through a power-up sequence. The seat will go silent
when the power-up is complete.
Refer to the Homeowners Guide to test the seat features.
1341257-2-E
10 Kohler Co.