Dörr LV-WRC Manual De Instrucciones página 13

Channel Setting
CH • 3 channels are available: A, B & C. You can operate control up to 3
A B C
cameras in the near vicinity without causing any interference. Function
will be identical for all channels.
Important: Make sure that both devices (transmitter and receiver) are set to the
same channel. Otherwise proper function is not guaranteed.
How to use the Receiver:
Loading the Battery in Receiver
1. Slide the battery compartment lid open.
2. Place the supplied battery BL-6F into the battery compartment. Make sure that the
contacts of the battery match with the contacts of the receiver.
3. Slide the lid onto the battery compartment until it clicks closed.
Note: The fully charged Li-Ion battery BL-6F will last about 600h in standby mode.
If the receiver and LC display are in active use, it will last app. battery using the supplied
charger or replace the battery against a freshly charged one. 4 h. When the battery is
depleted, the function indicator will blink. Now you need to recharge the battery using the
supplied charger or replace the battery against a freshly charged one.
Channel Setting
• 3 channels are available: A, B & C. You can operate control up to 3 cameras in the near
vicinity without causing any interference. Function will be identical for all channels.
Important: Make sure that both devices (transmitter and receiver) are set to the same
OFF ON CH A B C
channel. Otherwise proper function is not guaranteed.
Turn the Transmitter on
1. Set the power switch to position ON.
2. The power indicator will glow in red color once the main switch is on.
3. When the transmitter is properly connected with the camera with the correct cable,
the video function indicator glows in red color.
Turn the LCD Display of the Receiver On
When the receiver is switched on, the LC display is still off power. It must be switched on
separately. Press the LCD power switch 1x. If you wish to switch it off again, press the
LCD power switch 1x again.
Adjust L C D
LC Display Brightness Adjustment
1. If you wish to increase the brightness of the LC display, press the function switch in
direction "top". If you wish to reduce brightness, press the function switch in
direction "bottom". You can adjust brightness in 4 steps.
Connect the Image Receiver directly to the Camera
In some cases it will be of advantage to connect the image receiver directly to the
camera alternatively to the wireless transmission, e.g. to avoid blurred image
caused by interference by radio waves from other devices.
GB
13