Publicidad
Idiomas disponibles
Idiomas disponibles
TOOLS
1 Adjustable claw
2 Sliding bar
3 Sliding hammer
INTENDED USE
This injector puller is used to disassemble Common Rail injectors. The tool can be attached with the
adjustable claw at two opposite points of the injector and allows a removing of even stuck injector by
using the slide hammer.
SAFETY INFORMATION
• Do not use the tool if parts are missing or damaged.
• Only use the tool for work that is specified under intended use.
• Never place the tool on the vehicle battery. There is a risk of a short circuit.
• Be careful when working on running engines. Loose clothing, tools and other objects can be
caught by rotating parts and cause serious injury.
• Be careful when working on hot engines because of the risk of burn injuries!
• Keep children and other unauthorized persons away from the work area.
• If you remove the ignition key before repairing, you can prevent the engine from being started
accidentally.
• Be careful when working on high pressure lines. Release pressure before working on high
pressure lines.
• This manual serves as a brief guide and does not replace a workshop manual. Always refer to
the vehicle-specific service literature, particularly the technical data such as torque values and
instructions for disassembly/assembly, etc.
USE
Common Rail
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Universal Injector Puller
1
1
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
3
4
2
5
6
4 Stop nut
5 Handle
6 Pulling hook for Pump Nozzle Unit
Pump Nozzle Unit
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
9824
6
Publicidad
