Bracket Assembly - MTD 190-180 Manual Del Operador

3
Attaching
Bracket
Assembly
Model Series 600
IMPORTANT:
Before assembly,
place the tractor on
a firm, level surface,
disengage the PTO,
stop the tractor
engine and set the
parking brake.
NOTE:
There are two holes
in the clevis pin.
Be sure to insert
the hairpin clip in
the upper hole to
properly secure the
bracket assembly to
the hitch plate.
Attaching The Bracket
Assembly
Model Series 600
IMPORTANT: Before assembly, place the tractor on
a firm, level surface, disengage the PTO, stop the
tractor engine and set the parking brake.
1. For convenience, pivot the seat forward and leave
it in that position until the grass collector is fully
mounted and assembled.
2. Position the hooked ends of the bracket assembly
over the shoulder bolts (1). Swing in the bottom of
the bracket assembly down and in (2) over the hitch
plate and aligning with the hole on the hitch plate.
See Fig. 3-1.
3. Insert the clevis pin (B1 in Fig. 2-2) through the
aligned holes in both the bracket assembly and the
hitch plate and secure with the hairpin clip (B2 in Fig.
2-2). Refer to Figure 3-2.
NOTE: There are two holes in the clevis pin. Be sure
to insert the hairpin clip in the upper hole to properly
secure the bracket assembly to the hitch plate.
Hitch Plate
Figure 3-1
Figure 3-2
6
Upper Hole