Wall Mounting - Uline H-7272 Guia De Inicio Rapido

WALL MOUNTING

1. Use flathead screwdriver to loosen screws on lens.
(See Figure 2) Remove lens and set aside.
Figure 2
Frame
Faceplate
Lens
Screws
2. Remove faceplate from frame and set aside.
3. Drill or knockout appropriate knockouts on
backplate to fit junction box mounting points.
CEILING OR END MOUNTING
1. Use flathead screwdriver to loosen
screws on lens. (See Figure 3)
2. Remove lens and set aside.
3. Remove faceplate from frame and
set aside. Drill a 3/4" hole through the
desired mounting knockout located
on the frame of the sign. For ceiling
mount, knockout is located on the
top of the frame. For end mount,
knockout is located on side of frame.
4. Using provided hardware, thread
nut onto pipe nipple through
canopy center hole.
5. Remove backing from junction
box gasket and adhere to back of
canopy. (See Figures 4-5)
Figure 4
PAGE 2 OF 9
INSTALLATION CONTINUED
Wire Nuts
Junction
Box
Diffuser
Chevron
Figure 3
Faceplate
Lens
Screws
6. Remove backing from self-adhesive seal ring and adhere to
Figure 5
front of mounting canopy. (See Figures 6-8)
Figure 6
4. Drill or knockout center hole in backplate for supply
wire leads.
5. Remove backing from self-adhesive junction box
gasket and adhere to backplate.
6. Route input wires through center holes of backplate
and make wiring connection. For 120V, use black
and white wires; for 277V, use red and white wires.
7. Secure backplate to junction box (hardware not
included).
8. Remove proper chevron(s) as required.
NOTE: Remember to reinstall the diffuser once
chevron(s) have been removed.
9. Connect battery to lamp board.
10. Secure faceplate and security torque screws.
NOTE: Push center of lens to balance when
tightening screws.
11. Apply continuous AC power and press test button to
check operation.
Exit Stencil
Frame
Nut
Pipe
Nipple
Diffuser
Seal
Ring
Chevron
Figure 7
Diffuser
Nut
Screws
Mounting
Mounting
Canopy
Plate
Junction Box
Gasket
Figure 8
Screws
Lens
Wire Nuts
Junction
Box
0621 IH-7272