Cleaning Your Appliance - Moulinex Easy Soup LM841B10 Manual Del Usuario

800g of fruit as a maximum, using a minimum of 150ml liquid.
• Stir the liquid and ingredients together manually (fig 4).
• Place the motor unit back on the top of the jug, ensuring that the two connection
points (parts D and E) fit together properly (fig 5).
• Plug one end of the power cord into the side handle and connect the other end
to the mains socket (fig 6).
• All the settings on the control panel will flash.
USING THE SETTINGS
• Choose your preferred setting by pressing the corresponding button (fig 7). Only
the chosen setting will flash.
• Press the start button to start the programme. The appliance will beep, and the start
button and chosen setting will stay lit up until the programme has finished (fig 8).
• Once the programme has finished, the appliance will beep again. After settings
P1, P2 and P3, the appliance will automatically switch to keep-warm mode for
40 minutes and the button will light up (fig 9).
Note: You can stop the programme at any time by pressing the start/stop button
again.
If a soup-making cycle is interrupted by pressing the start/stop button or by
opening the motor unit, preparation should be restarted and you should wait
20 mins for the appliance to cool down, before restarting the programme.
• Unplug the cord from the mains socket, and then remove the jug.
• Hold the side handle of the jug with one hand and remove the motor unit by
pulling up the top handle with the other hand (fig 1).
• You can now pour the soup, smoothie or compote into a container.
Tip: For a smoother soup, you can then press the blend setting (P5) to give it
a creamy texture.
To familiarise yourself with the appliance, we suggest you try out one of the
recipes from the recipe booklet.

CLEANING YOUR APPLIANCE

• Before first use or to clean the appliance as indicated below:
- Open the appliance (fig 1) and fill the jug with 1.2 L of hot water from the
tap (up to the MAX level) (fig 3). Do not add washing-up liquid to the jug.
- Put the top back on (fig 5) and plug it in (fig 6).
- Press the P4 Easy cleaning button (fig 10).
- When you hear the beep indicating the programme has finished, open the
appliance (fig 1), empty the water and rinse inside the jug (fig 11).
• Do not immerse the appliance in water. Do not place the motor unit (B) or the
jug (I) under running water.
• If necessary, once the appliance has cooled down, wash the blade under the tap
13
EN