Würth 1952 003 200 Traducción Del Manual De Instrucciones De Servicio Original página 17

plugs easily break in their seat.
• Specifications for use:
Dimension A ≥ 14 mm (M10)
Dimension A ≥ 20 mm (M9, M8)
Dimension L ≤ 13 mm
• L (thread)
L
THE USE OF THIS EQUIPMENT REQUIRES
ATTENTION AND CARE IN POSITIONING ON THE
AXIS OF THE GLOW PLUG TO AVOID PROBLEMS
ON THE HEAD AND TO AVOID THE RISK OF
BREAKING THE TOOLS; IT CAN BE HELPFUL TO USE
AS REFERENCE THE INCLINATION OF ADJACENT
GLOW PLUG (SMALL DIFFERENCES: ± 5 ° ARE NOT
SIGNIFICANT FOR THE FINAL RESULT).
IMPORTANT - During the drilling phase with two-diameter drill
(for the removal of the upper threaded part of the glow plug), to
preserve the quality of the drill and increase its duration, follow
absolutely these notes:
1) MAX number of revolutions: 200 revolutions/min
2) After a few mm of drilling depth (1÷3 mm), remove the drill
and lubricate with cutting fluid, blow the seat of the glow plug
to remove the metal shavings.
Carry on the drilling phase in this way till the complete
removal of the threaded part of the glow plug.
PROCEDURE
All of the following steps must be performed with the utmost care,
precision and attention
A
3
4
17