Securing Your Cover; Important - ShelterLogic Round Top 201133 Instrucciones De Ensamblaje

10. seCuRINg YouR CoVeR:

A. Install the "S"- hook from the ratchet assembly into the legs of
the shelter. Pull the webbing carefully to remove the slack from the
cover. Do not to pull the webbing through the opposite side of the
cover.
B. Insert the webbing through the spindle of the ratchet and pull
tight. see Detail O. wind the ratchet until the webbing overlaps
itself. Repeat these steps on the opposite side, then repeat this
on the back side of the shelter.
C. When all of the corners are secured, adjust the cover front to
back so that it is centered. When the cover is centered, tighten all
of the ratchets. Do this in an "X" pattern to be sure it is tightened
evenly. see Detail O.
D. Install the cover rails (10110) by inserting them into the pipe
pockets on each side of the cover. Bolt (10115) the rails to the ribs
using the 3-way and 4-way clamps as shown in Detail P. Check
that the rails are evenly spaced 8" above the ground on both
sides. Push down on the cover rails and connectors, one at a
time, to tighten the bolted clamps and the cover.
IMPORTANT: Install bolt caps (10150) on exposed bolts on side
rails and wind braces to prevent injury.
DETAIL P
NoTe: CHeCk THAT
YouR CoVeR Is
CoRReCTlY PlACeD
oN THe FRAMe.
The ShelterLogic ® logo should line
up on the left front and right rear
corners near the top rail. If the logo
is not legible and positioned as
shown as "incorrect", the cover has
not been put on the frame correctly.
10115
Cover Tightening Tip
Check and
tighten Ratchets
and Cross Rails
monthly to ensure
the cover is tight.
cOrnEr LEG
WARNING: Serious injury to persons or property could result if cover is installed and shelter is not
completed and is left unattended. Shelter must be securely anchored until completed.
05-201133_13-0D
DETAIL O
cOrrEcT
IncOrrEcT
Clamps
Clamps
10115
10111
11102
01010
01010
mIDDLE LEG
Page 10
OuTsIDE
cOrnEr
VIEw
Avant de commencer: Il faut 2+ personnes ou plus pour le montage qui prend environ 3 heures.
Outils recommandés: lunettes de sureté, corde, mètre, cliquet avec Douille d' 1.1cm (7/16po), clé è molette,
10110
escabot/echelle, Maillet de caoutchouc, Couteau d' utilitaire.
LEs TrADucTIOns FrAnçAIsEs
D'InsTrucTIOn D' AssEmbLAGE
lire TouTes les instructions avant de monter.
Cet abri DoIT être bien ancré.
Page 11
fabriqué sous brevet des états-unis
D415,571 D430,306
D409,310 D414,564
Autres brevets en instance
05-201133_13-0D