Accessories - Riello RS 25/M BLU FS2 Instrucciones De Instalación, Montaje Y Funcionamiento

ACCESSORIES

(optional):
• KIT FOR LPG OPERATION: the kit allows the RS 25-35/M BLU burners to burn LPG.
BURNER
Output kW
Blast tube length mm
Code
• KIT FOR MODULATING OPERATION
Output power regulator kit RWF40
Two components should be ordered:
• the Output power regulator to install on the burner;
• the Probe to install on the heat generator
Parameter to control
Adjustment field
Temperature - 100...+500°C
0...2.5 bar
Pressure
0...16 bar
• POTENTIOMETER KIT FOR THE INDICATION
OF LOAD POSITION
• MAXIMUM GAS PRESSURE SWITCH
• LONG HEAD KIT BURNER RS 25/M BLU
• LONG HEAD KIT BURNER RS 35/M BLU
• KIT POST-PURGING: to obtain this function, disconnect the wire from the equipment terminal 6 and connect it to the equipment terminal 7; see wiring
diagram on page 19.
• GAS TRAINS TO COUPLE WITH THE BURNER, ACCORDING TO REGULATION EN 676 (complete with valves, pressure adjuster and filter): see page 9.
NOTE: The installer is responsible for the addition of any safety device not foreseen in this manual.
RS 25/M BLU
80/125 ÷ 370 kW
230 - 365
3010423
Probe
Type Code
PT 100 3010110
RWF40
Output probe 3010213
4...20 mA 3010214
Code 3010420
Code 3010418
Code 3010430
Code 3010431
3
OUTPUT
SIGNAL 4-20 mA, 0-10V
Two components should be ordered:
• the Analogical signal converter;
• the Potentiometer
Output power
Potentiometer
regulator
Type Code Type
3010417 ASZ...
• KIT GROUND FAULT INTERRUPTER
• KIT CONTINUOUS PURGING
• KIT HOURCOUNTER
• KIT CLEAN CONTACTS
RS 35/M BLU
120/200 - 470 kW
230 - 365
3010424
POWER REGULATOR WITH
Analogical Signal
Converter
Code Type Code
3010420 E5202 3010410
Code 3010448
Code 3010449
Code 3010450
Code 3010419