PLEASE READ THIS OWNER'S MANUAL THROUGH CAREFULLY BEFORE ASSEMBLING,
USING AND SERVICING THE WORKOUT CYCLE! FOLLOW THE INSTRUCTIONS DESCRIBED
IN THIS MANUAL CAREFULLY.
THE EQUIPMENT HAS BEEN DESIGNED FOR HOME USE ONLY. THE TUNTURI WARRANTY APPLIES
ONLY FOR FAULTS AND MALFUNCTIONS IN HOME USE. PLEASE NOTICE THAT THE WARRANTY DOES
NOT COVER ANY DAMAGES DUE TO NEGLIGENCE OF ADJUSTMENT OR MAINTENANCE
INSTRUCTIONS DESCRIBED IN THIS MANUAL!
The figures referred to in the text are in the back fold.
NOTE ABOUT YOUR HEALTH
*
Before you start any training, consult a physician to check your state of health.
*
If you experience nausea, dizziness or other abnormal symptoms while exercising, stop your workout at
once and consult a physician.
*
To avoid muscular pain and strain, begin each workout by warming up and end it by cooling down (slow
pedalling at low resistance). Don't forget to stretch at the end of the workout.
NOTE ABOUT THE EXERCISING ENVIRONMENT
*
The device is not to be used outdoors.
*
Place the cycle on a firm, level surface.
*
Make sure that the exercising environment has adequate ventilation. To avoid catching cold, do not
exercise in a draughty place.
NOTE ABOUT USING THE EQUIPMENT
*
Place the machine on a protective base.
*
If children are allowed to use the cycle, they should be supervised and taught to use the cycle properly,
keeping in mind the child's physical and mental development and their personality.
*
The magnet caliper of the brake forms a magnetic field which may damage the mechanism of a watch or
the magnetic identification tape of a credit or cash card if they come into immediate contact with the
magnets.
*
Before you start using the cycle, make sure that it functions correctly in every way. Do not use a faulty
device.
*
Only one person may use the cycle at a time.
*
Hold the handlebar for support when getting on or off the cycle.
*
Wear appropriate clothing and shoes when exercising.
*
Press the key with the tip of your finger; your nails may damage the key membrane.
*
Always dry the surface of the meter if there are any drops of sweat on it.
*
Do not attempt any servicing or adjustment other than those described in this manual.
*
The device must not be used by persons weighing over 110 kg.
ASSEMBLY
Ensure that the following parts are in the package:
1.
Frame
2.
Rear support
3.
Handlebar support tube + meter
4.
Pedals (2)
5.
Ear sensor for pulse measurement
6.
Fastening screws (2 hex screws) and washers (2)
for the rear support, white decorative caps (2) for
the rear support screws, batteries (2)
7.
Fastening screw, washer and rectangular metal
washer for the handlebar support tube
8.
Assembly tools
If necessary, contact the dealer and give the model, serial
number and spare part number (see the back of the manual).
The package includes a silicate bag for absorbing moisture
during storage and transportation.
INFORMATION AND WARNINGS
Left, right, front and back are as seen from the exercising
position. Assemble the device as follows :
REAR SUPPORT
Place the support under the rear part of the frame and fasten
it with two hex screws and washers. Press the caps onto the
fastening screws (Fig. 1).
HANDLEBAR SUPPORT TUBE
Lean the cycle over on one side so that it rests against a
chair, for example. Remove the protective foam from the
support tube and fit the handlebar support tube into place
so that the resistance adjustment knob at the top of the tube
points to the back (Fig. 2).
If the handlebar support tube will not go into the hole in the
grey top cover, undo the screw at the lower end of the cover
so that the cover can be moved, and fit the tube in.
Remember to retighten the screw after fitting the support
tube. Make sure that the resistance adjustment wire coming
out of the lower end of the handlebar support tube and the
3