LEXIBOOK LCDDVD2TFFR Manual De Instrucciones página 39

Language setup
Use the ▲and▼ keys on the remote control to select "LANGUAGE SETUP". Then use the ▲/▼/◄/► to
select the menu options.
Note: To exit the menu, select "EXIT SETUP" and press ENTER or press the DVD-SETUP key at any
ess moment.
OSD language selection
The menu language used in these instructions is English. You can also set the OSD (on-screen display)
to other languages.
type, 1. Use the ▲and▼ keys on the remote control to highlight "OSD LANGUAGE", then press►.
2. Use the ▲and▼ keys on the remote control to select the desired on-screen display language. Press
ENTER to confirm your selection. The available languages are English, German, Spanish, French,
Portuguese and Italian.
ote
OOM: Other language settings
In the "LANGUAGE SETUP" menu, you can also set the default language for the audio ("AUDIO LAN"),
subtitles ("SUBTITLE LANG") and the menu language of your DVD player ("MENU LANG").These
settings will only take effect if the DVD disc being played supports the language selected. If so, the
language selected will be displayed first during audio, subtitle and menu language settings. Use
the▲/▼/◄/►and ENTER keys to adjust the settings.
Audio setup
Use the ▲and▼ keys on the remote control to select "AUDIO SETUP". Then use the ▲/▼/◄/► keys to
select the menu options.
Note: To exit the menu, select "EXIT SETUP" and press ENTER or press the DVD-SETUP key at any
moment.
Audio output
You can change the "AUDIO OUT" setting between: "SPDIF / OFF", "SPDIF / RAW" and "SPDIF / PCM".
• SPDIF / RAW
Choose this setting if your DVD player is connected to a power amplifier with a coaxial cable or an optical
cable. When playing a disc recorded with Dolby Digital, DTS and MPEG audio formats, the
corresponding digital signals will be output from the Coaxial Output jack. This player's digital output jacks
are designed for a connection to a Dolby Digital, DTS or MPEG receiver or decoder.
• SPDIF / PCM
Choose this setting if your DVD player is connected to a 2-channel digital stereo amplifier. When playing
a disc recorded with Dolby Digital and MPEG audio formats, audio signal will be modulated into a
2-channel PCM signal and it will be output from the Coaxial Output jack or Optical Output jack.
Tone
Use the ▲ and ▼ keys to adjust the tone.
Digital setup
Use the ▲and▼ keys on the remote control to select "DIGITAL SETUP". Then use the ▲/▼/◄/► keys
to select the menu options.
Note: To exit the menu, select "EXIT SETUP" and press ENTER or press the DVD-SETUP key at any
moment.
Dynamic range
When "SPDIF / RAW" is selected, you can set the line out ratio to get a different effect. Use the ▲and▼
keys on the remote control to adjust the settings. If adjusting to "FULL", the audio signal peak volume will
be the minimum; while adjusting to "OFF", the volume will be at its maximum. You can also select "6/8",
"4/8" or "2/8".
Dual mono
Use this option to select the audio output type: "STERO", "MONO L", "MONO R" or "MIX MONO".
39