About Radio Reception - Oregon Scientific RM329P Manual Del Usuario

To install the adapter:
1. Insert adapter into jack at the bottom of the unit.
2. Plug the adapter into an electrical wall outlet.
Using the AC power adapter allows for continuous projection. Once
the AC power adapter has been plugged into the RM329P and an
electrical wall outlet, slide Button O to the right (with back cabinet
facing) to activate the continuous projection feature. To turn off the
continuous projection feature, slide Button O to the left (with back
cabinet facing).
Note: Slide Button O will only activate the continuous
projection feature when the AC power adapter is properly
connected to the RM329P and an electrical wall outlet. For
momentary projection, use the [ SNOOZE ].
HOW TO USE THE BACKLIGHT
Press [ SNOOZE ] once. The backlight will activate for five seconds.
The projection will also be on for five seconds.

ABOUT RADIO RECEPTION

The RM329P is a radio frequency (RF) controlled clock. The
current time and date will automatically synchronize with radio
frequency signals generated from DCF77 Frankfurt, Germany. The
benefit of a RF controlled clock is that highly-accurate time is
maintained and manual adjustments to the time and date are not be
required.
When the batteries are first installed, the RM329P will automatically
search for a radio signal.
When in search mode, the antenna icon [
process takes between two (2) and ten (10) minutes. After initial
search, short periodic reception-signal scans will commence several
times a day.
The antenna icon indicates the quality of reception.
When signal reception is complete, the antenna icon will stop
blinking.
Interference
Reception of the signal can be affected by many factors including
interference from other RF signal generating or receiving equipment,
placement near a PC, TV, radio or microwave oven or location
within a steel reinforced concrete building.
4
] will blink. This
- Strong
- Weak
- No Reception
- Receiving