Kenmore 116.32728 Manual Del Propietário página 20

Note: See PARTS AND FEATURES for belt
number.
Loop the other end of the belt on the belt
pulley on the agitator
Insert the agitator by p{acing the rounded
portion of the end cap down into the slot in
the nozzle base,
Note: It may be necessary to hold the furni-
ture guard out of the way in order to allow
proper insertion of the agitator into the noz-
zle base_
Nozzle
Agitator Base
Furniture End Base
Guard Cap Slot
Note: Care must be taken due to the belt
tension during reassembly_
A
Press firmly,
checking to
see that
each end is
completely
inserted°
Check to see that the belt is centered on
the belt pulley_ Turn the agitator with your
fingers to see that it turns freely°
To re-attach
the agitator
cover, insert
the six (6)
tabs into the
six slots
along the
front edge of
the nozzle
base.
Tabs!
Slots
@It
Locking
Tabs
Lower the agitator cover to its original posi-
tion,, After positioning the agitator cover,
push forward on the two (2) locking tabs in
order to ensure that they are securely in
place,
Re-fasten the
furniture
guard retain-
ers to the
posts on both
sides of the
agitator
cover,
Agitator
Cover
Furniture
Guard
Retainer
Note: If the agitator cover is not installed
correctly, you may experience a loss of per-
formance and possible agitator vibration,
etc.
Place jj_.,
Make sure the headlight wires are tucked
securely in place.
Latches
Replace
the nozzle
cover and
secure the
latches..
Nozzle Co'
2O