Suggested Pile Height Settings - Kenmore 116.32728 Manual Del Propietário

To select a
pile height setting:
Turn off cleaner_ Select a pile height setting
by tilting the cleaner back until front wheels
are lifted slightly off the floor as illustrated.
Slide the adjustment lever to the correct
setting,
SUGGESTED PILE HEIGHT SETTINGS
"You may need to raise the height to make
some jobs easier, such as scatter rugs and
longer pile carpets. Suggested settings are:
HIGH: shag carpet, long pile, plush, scatter
rugs.
MED: medium to tong pile.
LOW: short to medium pile,
EX LOW: very low pite.
WARNING
Personal Injury Hazard
DO NOT place hands or feet
underneath the unit when chang-
ing from the bare floor to the car-
pet pile height setting. The agita-
tor begins to revolve rapidly when
the vacuum is turned on and is in
the carpet setting.
Bare floor setting: Slide the carpet/bare
floor selector all the way back and down
toward the bottom of the nozzle until it locks
into place°
In this position the brush assembly does not
revolve. This setting should be used for
cleaning hardwood and tile floors and when
any attachments (tools) are used,
Carpet setting: Slide the selector all the
way forward and up to the carpet
position.
In this position the brush assembly will turn.
When carpets are being cleaned the selec-
tor should be in this position.
Attention: Refer to your carpet manufac-
turers cleaning recommendations. Some
more delicate carpets may require that they
be vacuumed with the agitator turned off, to
prevent carpet damage,
CAUTION
Do not allow vacuum cleaner to [
remain in one spot for any length of [
time when the agitator is turning.
Damage to carpet may,,,Occ,u,r. ,,I
Note: For longer belt life, turn vacuum off
before moving selector Failure to do so can
cause the belt to rub on the selector shaft
and may result in the belt becoming hot and
creating a burning rubber smell.
Carpet/Bare
Floor Selector
To Bare Floor _"
Position
To Carpet
Position