Kenmore 116.32728 Manual Del Propietário página 24

Review this chart to find do-it-yourself solutions for minor performance problems. Any service
needed, other than those described in this owner's manual, should be performed by a Sears
authorized service representative,
Cleaner wol3_t rurL
Poor job of dirt pick-up.
Cleaner picks up
moveable rugs or
pushes too hard.
Light won't work°
Agitator does not turn.
Performance indicator,
some models, is red.
1, Unplugged at wall outlet
2. Tripped circuit breaker/blown fuse
at household service panel.
3. Onloff switch not turnedon,
4. Thermal protector tripped
1,, Full or clogged dust bin,
2. Wrong pile height setting
3. Worn agitator,
4. Clogged nozzle or dust bin port.
& Clogged hose.
6. Hole in hose
7.. Brokentmispiaced heir,
8. Hose not inserted fully
g. Motor protection system activated
10. Dirty filters,
11, Sliders not rotating,
1. Wrong pile height setting
1. Burned out light bulb,
1, Broken belt
2,, Bare floor selector in bare
floor setting.
3. Belt installed incorrectly.
1., Full or clogged dust bin
2. Dirty filters,
3. Clogged airflow passage
1. Plug in firmly, push onfoff switch to on.
2o Reset circuit breaker or replace fuse
3o Push onloff switch to on.
4 Reset thermal protector, (page 12)
1. Clean dust bin, (page 15-t6)
2. Adjust setting, (page 7)
3. Replace agitator, (page 23)
4. Check CLOG REMOVAL, (page 21)
& Check for clogs, (page 21)
6. Replace hose,
7. Replacetfix belt, (page 18-20).
8. Insert hose fully, (page 5)
9o Check for clogs, (page 21)
10o Cleanlchange filters, (page 16-17)
11. Remove obstructions, (page 15)
1_ Adjust selling, (page 7)
Io Change light bulb, (page 22).
i_ Replace belt, (pages 18_20)
2_ Move selector to the carpet setting,
(page 7).
3_ Check BELT CHANGING AND
AGITATOR CLEANING, (pages 18-20).
2_
3_
Clean dust bin, (page I5-t6)
Cleantchange filters, (page 16-17)
Clear clog from airflow passage,
(page 21).
This is normal Light should go off
when tool is removed
4. Cerlaln attachment tools 4o
Air flow restricted t_ Attachment use restricts air flow, t. Check ATTACHMENTS, (page 8)
with attachment use. 2. New carpet fuzz clogged air path. 2, Check CLOG REMOVAL and clean
Sound changes, hose, (page 21)
Excessive noise as 1_ Belt rubbing on carpet/bare floor I. Push selector all the way forward,
vacuum is shut off° selector shaft, (page 7)
Dirt Sensor, some 1. Dirty optic cells 1, Clean oplic cells, (page 13).
models, will not work.
24