PRASTEL EASYBKA Manual De Instrucciones página 38

EASYBKA - EASYBKR
5.1.4 Changing from Bypass Mode to Normal Mode:
To set the Normal/Bypass code refer to
par 14.
1. Insert the code. Mode LED will
flash green.
2. Press the "#" key to confirm the
Mode change. Mode LED will turn
green.
6. Auxiliary Input and Output
The EASYBKA/R auxiliary input and output can be configured in
different combinations, for optimum usability in different applications.
(see par.15).
7. Request to Exit (REX) Button
The REX button must be located inside the premises to be secured and
is used to open the door without the use of a proximity card or PIN code,
it is usually located in a convenient location, e.g. Inside the door or at a
receptionist's desk. The function of the REX button depends on whether
the Lock Strike Relay is programmed for Fail Safe Operation or Fail
Secure Operation.
1. Fail Secure Operation: From the moment the REX button is
pressed, the door will be unlocked until the "Lock Strike Release
Time" has passed. After this time, the door will be locked even if
the REX button has not been released.
2. Fail Safe Operation: From the moment the REX button is pressed,
the door will be unlocked until the REX button is released, plus
the "Lock Strike Release Time". In this case the "Lock Strike
Relay" only begins its count down once the REX button has been
released.
ENGLISH
38
ISEASYBK_08_18.pdf.docx
ORANGE
GREEN
GREEN