PRASTEL EASYBKA Manual De Instrucciones página 42

EASYBKA - EASYBKR
9. Changing the backlight and LED behavior
1) Enter Programming Mode
2) Press "6" to enter Menu 6,
the Mode LED will flash
green.
3) Construct
code using the following
instructions:
the first digit is 5, indicating
the backlight
option, the second digit is
the option number for the backlight mode that you wish to select (see
the following table). The third and fourth digits are 0.
4) System returns to Transmit Mode, you will hear one beep, the Door
LED will turn off and the Mode LED will turn green.
WARNING: In modes 2 and 3, backlight is actually turned off or
dimmed 10 seconds after programming.
Backlight and LED mode
LED active, backlight OFF
LED active, backlight ON (default)
LED and backlight OFF, both activated on any key
press for ten seconds.
LED active / backlight Dimmed, backlight
activated on any key press for ten seconds.
10. Changing the Open Code
The Open Code is mainly used as a method to quickly test the Lock
Strike Relay during installation.
The Default Factory Setting for the Open Code is 2580.
and enter a
and Led
ENGLISH
42
ISEASYBK_08_18.pdf.docx
Option number
0
1
2
3