Tool it NBT 200 Manual De Instrucciones página 7

Translation of the original instructions
Yellow LED
Red LED
4. Continue the test by pressing «ENTER». The tester returns to the main menu.
5. Turn on the heater, headlights, etc. Do not switch on cyclic loads (air condi-
tioning and windshield wipers).
6. To test the charging system with the accessories, press «SYST» again and
repeat the above procedure.
• Charge system test result (with consumables)
Examples
Green LED
Yellow LED
The red ones
DISPLAY SCREEN CASE
Examples
The display shows HI
The display shows Lo
The screen is blank
"The screen flashes or dis-
plays « ----»"
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase
(parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disas-
sembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
The alternator does not provide enough power to the batte-
ry. Check the alternator belts, and make sure the alternator
is running when the engine is running. If the belts slip or
are broken, replace them and re-test. Check the connection
between the alternator and the battery. If the connection is
bad, clean or replace the cable and re-test. If the alternator
belts and connection are in good condition, replace the alter-
nator.
Check that the connections are good. If everything is pro-
perly connected, replace the alternator.
Good charging system
Check connections, cables and alternator
Problem with the charging system, Check the alterna-
tor.
The battery voltage is too high for the tester.
The battery voltage is too low for the tester. Recharge
the battery and repeat the test.
The battery voltage is too low for the tester. Recharge
the battery and repeat the test. If the display remains
the same, replace the battery.
The voltage is not stable. Charge the battery, then
retest it. If the display remains the same, replace the
battery.
NBT 200
Analysis
Analysis
EN
7