Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Steps
Remove tape liner from front and rear flanges of visor. Peel back
2" (5 cm) of tape liner from each end of the lateral flange.
free end
lateral flange
rear
flange
2
Depending on your application, see the appropriate cross section below for proper visor placement.
black vinyl trim
foam tape
PRESS
visor
4
Gently press the exposed areas of tape against the surface and
verify position. With the visor in its final position, remove the
remaining tape liner by pulling on free ends.
5
4 Piece Set
The rear visor attaches with the same
preparation methods as the front visor.
7
NOTE: Actual application may vary slightly from illustrations.
free end
front
flange
inside face of
window frame
window glass
Align visor to the previously cleaned surface. The lateral flange
attaches to the chrome or black trim. The front flange will attach on
top of the mirror base plate.
3
chrome trim
PRESS
OR
visor
rubber window
channel
Apply pressure along all flanges to ensure proper adhesion of tape.
6
Repeat Steps 1-7 for opposite side.
Page 2 of 3
Publicidad
Tabla de contenido
