Electrical Connections - MARTINS Industries TC-15 Manual Del Usuario

DOLLY INSTALLATION (OPTIONAL)
Complete the assembly of the dolly with
the assembly guide included in the
conveyor dolly packaging. Then select
the desired angle for your conveyor.
Before the installation of the conveyor make
sure that the brakes on the dolly are engaged.
To handle and install the Conveyor onto the dolly refer to the handling - installation instructions p. 03

ELECTRICAL CONNECTIONS

Connect the electrical power source.
Americas
Electricity
World
Electricity
Connect the electrical power source of the conveyor and make sure
that the breaker is turned to the ''ON'' position.
The conveyor should be connected to an electrical power source meeting the electrical specifications
of the product (see the manual or sticker inside the service box).
The power cable should run outside of the work area. The top control box should be installed near the top
work area, at a height of 0.6 m to 1.7 m / 24" to 67" from the ground (see work area p. 05)
Align the holes at the base of the conveyor with the holes
of the dolly and bolt them together.
TC-15 & TC-18
115V - 1Ph - 60Hz - 12A - 750W - 1Hp
230V - 1Ph - 50Hz - 7A - 750W - 1Hp
Before modifying the dolly's angle make sure that
the brakes on the dolly are engaged.
TC-21 & TC-24
230V - 1Ph - 60Hz - 12A - 1500W - 2Hp
230V - 1Ph - 50Hz - 13A - 1500W - 2Hp