auna Microstar 10035301 Manual De Instrucciones página 36

EN
36
PROGRAM function
This function allows music tracks to be played in a programmed sequence.
NOTE: Program function can only be set in STOP mode
1. Press the PROGRAM button once. Program Number 01 will display and
PROGRAM INDICATOR will flash.
2. Press the SKIP FORWARD or SKIP BACKWARD button to select the track
to be programmed.
3. Press the PROGRAM button again to store the selection. The Program
number. will advance to 02 to prompt for the next input.
4. You may repeat steps #2 to #3 to program up to 20(CD)/99(MP3) tracks.
As soon as you have entered the 20th track, the LCD DISPLAY will show
"FUL", indicating that program is full.
5. Press the PLAY button to complete and start program play. Press STOP
button to stop program play.
6. You may use the REPEAT function to repeatedly play a certain track
(Repeat 1) or all tracks (Repeat All) in the Program Play Mode.
7. The CD player will stop when all the programmed tracks have been
played through once. To repeat program play, press the PLAY/PAUSE
button.
8. To cancel program play, press the STOP button twice while program play
is running or open the CD DOOR in stop mode.
Up to 20 (CD)/99(MP3) tracks can be programmed. If you attempt to
program more than 20(CD)/99(MP3) tracks, "FUL" will appear in the LED
DISPLAY.
Program Play mode
When finished programming, tap PLAY BUTTON to confirm and start
program play. The PROG INDICATOR in the LED DISPLAY will light. While
playing, you may tap the NEXT or PREV BUTTON to skip to a desired song in
the program list.
To stop program play temporarily, tap the STOP BUTTON once. The PROG
INDICATOR in the LED DISPLAY will remain ON.Tap PLAY BUTTON to
resume program play.
Note: if you tap the STOP BUTTON twice consecutively, you will cancel
program play and erase the program list permanently. The PROG
INDICATOR in the LED DISPLAY will go OFF.