Kohler K-1675 Guia De Instalacion página 4

Back Side Shown
Bottom
Surface
3" (7.6 cm)
3. Assemble the Walls
NOTE: Before proceeding, install the valving in the framing pocket.
Position the walls upright on a clean, flat surface with the flanges mating as shown.
Make sure the walls are both resting flat on the floor.
Clamp the walls together at the top and bottom using C-clamps. Make sure the bottom surfaces are
flush.
Mark the location of the holes on the flange with a felt tip marker.
Drill holes through both flanges with a 5/16" bit at each of the four marked locations.
Remove the clamps and apply a minimum 1/4" (6 mm) bead of mildew-resistant clear 100%
silicone sealant on one of the mating surfaces between the walls.
Reposition the walls together and assemble the bolt, washers, and nut at each location.
Wrench tighten. Do not overtighten.
1036225-2-D
C-Clamp
48-1/2"
(123.2 cm)
25-3/4"
(65.4 cm)
Back Side Shown
Washer
Bolt
3/8" (1 cm)
Top
Surface
71-1/4"
(181 cm)
4
Drill holes at the four
marked locations.
Nut
Lockwasher
Washer
Apply caulk/sealant here.
Kohler Co.