Kohler K-1675 Guia De Instalacion página 7

6. Pre-fit the Walls
NOTE: The module must be plumb and level. The shower door will not install properly if the module is
not plumb and level.
Carefully move the wall assembly onto the receptor.
Align the receptor and the walls.
Check and align the walls for plumb and level.
Confirm the correct location and depth of the valve.
If walls are not plumb and level, go to the "Shimming Procedures" section.
Predrill the nail-in flanges on the stud centers and around the walls on 8" (20.3 cm) centers. Do not
nail the walls in place at this time.
Kohler Co.
Confirm correct valve location.
Shower
Wall
Align these
two surfaces
on both walls.
7
Valve
Align these
8"
vertical surfaces
(20.3 cm)
on both walls.
1036225-2-D