La-Z-Touch 6-Motor Massage & Heat Recliner Operating Instructions - LAZBOY La-Z-Touch Instrucciones De Operación

Ocultar thumbs Ver también para La-Z-Touch:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

La-Z-Touch
6-Motor Massage & Heat Recliner
®
Operating Instructions
DANGER
– To reduce the risk of electric shock, serious injury or death:
• Plug directly into a wall outlet. Do not use an extension cord, adapter or surge protector.
WARNING
– To reduce the risk of serious injury:
• Sit down in the unit slowly. To avoid tip over, do not throw your weight against the
back of the unit. Move the unit into or out of the reclining position slowly, making sure
that no children or pets are in close proximity.
• To safely exit the unit and prevent a tripping hazard bring the back upright and close
the legrest.
Plug the 6-motor massage and heat power transformer directly into a wall outlet. Make
sure there is enough slack in the cord running from the chair to the outlet to allow for
rocking and reclining. Never stretch or strain a cord.
The massage and heat systems have an automatic timer that will shut off the massage and
heat functions after approximately 30 minutes of operation. The systems will remain off for
7½-minutes. If you select a massage or heat function before the cool down period is over,
either the PWR button or the HI or LO heat button will flash for 5 seconds, depending on
your selection. After the 7½-minute cool down period, you will be able to operate the
massage and heat systems for another 30-minute cycle.
Press the PWR button or any zone button (1, 2 or 3) to start the massage.
- Press the PWR button for a 15-minute massage, the PWR button light will change to
green when the 15-minute massage is activated.
- Press and hold down the PWR button for three seconds for a 30-minute massage,
the PWR button light will change to orange when the 30-minute massage is activated.
Press the LO or HI heat button to start the heat. The LO heat button light will change
to orange when low heat is activated, and the HI heat button light will change to red
when high heat is activated. The heat function will operate for 30-minutes, and can
be used without operating the massage.
When you are finished, make sure to push the PWR button and the LO or HI heat button
(if activated) to turn the systems off.
The chair will return to the off setting when power is restored, after a power outage
or interruption.
We recommend that you unplug the power transformer if you will be away from your residence
for an extended period of time.
16
La-Z-Touch
6-Motor Massage & Heat Recliner
®
Operating Instructions
P P O O W W E E R R
Activates the massage system.
Press once for a 15-minute
massage, or press and hold
down for three seconds for
a 30-minute massage.
L L O O H H E E A A T T
Activates the low
heat feature. Use
independently or
with the massage.
Z Z O O N N E E S S
Activates any or all zones.
LED indicates which zone(s)
has been selected.
1 Upper Back
2 Lower Back
3 Upper Thigh
S S P P E E E E D D
Controls pulsing frequency of
massage in PULSE mode and
controls velocity as it cycles
through in WAVE mode. Press (+)
to increase and (-) to decrease.
WARNING
– To reduce the risk of serious injury:
• Do not use unit if power control is damaged or wet. Do not use unit if the hand wand has
been dropped in water or any liquid. Contact your La-Z-Boy
H H I I H H E E A A T T
Activates the high
heat feature. Use
independently or
with the massage.
M M O O D D E E S S
SELECT - Choose any or
all zones for massage.
WAVE - Massage moves up
and down in a wavelike motion.
PULSE - Massage turns on and
off to simulate a pulsing action.
I I N N T T E E N N S S I I T T Y Y
Will increase (+) or
decrease (-) intensity
during all modes.
®
dealer for service.
17

Publicidad

Tabla de contenido
loading

Tabla de contenido