Dodge Neon 2000-2006; Dodge Ram 2002-2005; Dodge Viper 2003-2006; Plymouth Neon 2000-2001 - Metra T 99-6504 Instrucciones De Instalación

Dodge Neon 2000-2006/Plymouth
Neon 2000-2001
1. Pull off climate control knobs.
2. Unclip and remove A/C and heater vents.
(Figure A)
3. Remove (1) Phillips head screw from each
vent cavity.
4. Unclip and remove dash trim panel. (Figure A)
5. Remove (4) Phillips head screws securing
the radio. Disconnect and remove the radio.
Continue to kit assembly

Dodge Ram 2002-2005

1. Unclip the top edge of the trim panel
below the steering column. Note, it is not
necessary to completely remove this panel.
2. Remove (1) Phillips head screw from below
right A/C and heater vent.
3. Unclip and remove dash trim panel. (Figure A)
4. Remove (4) Phillips head screws securing
the radio. Disconnect and remove the radio.
Continue to kit assembly
Dash Disassembly 99-6504
(Figure A)
(Figure A)

Dodge Viper 2003-2006

1. Using a small flat blade screw
driver, pry up on center console
trim panel. Note, be careful not to
scratch the trim panel. (Figure A)
2. Loosen the shifter lock nut below
center console trim panel (Figure
A) and unscrew the shifter knob.
(Figure B)
3. Unplug electrical connectors and
remove center console trim panel.
(Figure C)
4. Remove (6) Allen screws from
radio/climate control trim panel
and (1) Phillips screw at the
bottom of the panel.
5. Unplug electrical connectors and
remove the panel. (Figure D)
6. Remove (4) screws securing
the radio. Disconnect and remove
the radio.
Continue to kit assembly
4
(Figure A)
(Figure B)