Beta 960w Instrucciones página 9

Select your operating system on the left menu and then follow the steps indicated on the
"install steps" section.
In the case that the software is installed on a 64 bits operating system then the system must
be rebooted after step 1 "install ready driver plus". After the system has rebooted, launch the
installer again and follow steps 2 and 3.
When the installation has finished, close the installation program and connect the 960W wire-
less receiver to any USB port, the operating system will recognize the receiver and the driver
installer will be launched, follow the instructions to install the driver.
When installing the driver could appear a screen indicating that the driver has not been appro-
ved by Microsoft, click on continue anyway.
Running the application:
The program can be launched using the Beta 960W icon that has been created on the desktop
or the icon at Windows>Programs>Beta 960W.
When the program starts the following screen will appear.
The grey icon at the centre of the display will blink while the program searches for a 960W re-
ceiver. As soon as the receiver is connected and the program detects it, the icon stops blinking
and the colour changes to blue.
When the icon is blue the program is ready to receive data from any compatible device.
Make the desired test using the 960TP or 960TAP tester and then print the data as specified
in the tester instructions. The receiver will get the data and will show the results on the scre-
en. The data shown depends on the tester used and the selected function.
960TP Pressure tester.
After the test has been done, press the print button on the 960TP tester, a screen similar to the
following will appear after successful data reception.
9