Acuity Brands AEDAN Instrucciones De Seguiridad-Instalacion Manual Operativo página 10

3f
10
3
Screw the HALF BALL onto the STEM and tighten
3f.
SET SCREW with the HEX KEY provided.
(Figure 3f)
3g. Lift up the MOUNTING PLATE so that the HALF
BALL sits in the pocket. The BOSSES should align
with the GROOVES in the HALF BALL.
Pull STEM wires through the CONTAINMENT TAB.
3h.
Reattach the CONTAINMENT TAB above the HALF
BALL and tighten the (2) #8-32 fasteners.
(Figure 3h)
Connect the RED and BLACK power leads from the
3i.
STEM with the RED and BLACK output wires from
the drivers using (2) two small WIRE NUTs provided.
(Figure 3i)
Re-attach the drivers onto the MOUNTING PLATE
3j.
using the two #8-32 fasteners. Pull the GREEN
ground wire from the STEM through either of the
WIRE ACCESS holes and keep it accessible.
(Figure 3j)
(Figure 3g)