Safety Inspection; Spare Parts - Forch 5430 5000 Manual De Instrucciones

Correct oil level is at the lower line of the filling hole (26) with the cylinder being fully upright
in vertical position, the rocker arm positioned downwards and the piston rod fully to the
inside. Too much oil results in a poor pump function.
Quantity of oil: 1,3 l.
Any good hydraulic oil of viscosity ISO VG 15 can be used.
NEVER USE BRAKE FLUID!

Safety Inspection

According to national legislation - minimum once a year though - the jack must be
inspected by a professional: by a professional for damages, extraordinary wear and tear;
the safety valve must be adjusted and the pump must be controlled for leakages.
Possible faults and how to overcome them
1. The load sinks and moves inadvertently. Verify whether there is enough room between
the lowering lever (46) and the handle tube. If necessary, adjust the two nuts (11) until there
is a play of 1-2mm, regardless whether the handle is in vertical or horizontal position.
2. The jack cannot lift to full height: refill oil
3. The load is dropping: leaking valves or worn out sealings. Please check the balls and
valve positions under the plug (30) and change the cylinder sealings.
4. The cylinder or the pump is leaking: Exchange the worn out sealings against new ones
out of the sealing set 0906000.

Spare parts

Replace worn or broken parts with genuine jack manufacturer supplied parts only. All major
parts may not be provided after discontinuation of a model.
Disposal
Oil must be drained off and legally disposed of.
Pos. Item -No.
36 050 00
1 02 121 00
2 02 204 00
3 02 224 00
4 02 261 00
5 02 307 00
6 02 328 00
7 02 346 00
8 36 003 00
9 36 006 00
10 336 007 00
11 36 008 00
12 36 009 00
13 36 010 00
14 36 011 99
15 36 012 00
16 36 051 00
pcs. Description
Trolley jack
2 Washer
2 Locking ring
8 Locking ring
2 Compression bearing (Seeger ring)
4 Screw
2 Screw
2 Screw
2 Wheel fork
1 Saddle
2 Wheel fixed
2 Wheel - movable
1 Plastic cap
1 Handle tube
1 Handle
2 Axle
1 Chassis frame