Gears - RedMax BHT250PD60 Manual Del Usuario

5.5.2 To assemble the power trigger
1. Put the power trigger (C) into the handle.
C
B
2. Put the handle stop (A) and the spring (B) into the
handle.
3. Assemble the rear handle. See
rear handle on page 19 .
4. Assemble the right chassis half and the front handle.
To remove the front handle on page 9 and To
See
disassemble the chassis on page 8 .

5.6 Gears

5.6.1 To remove the gear housing and the motor
from the chassis
1. Disassemble the front handle and the right chassis
To remove the front handle on page 9 and
half. See
To disassemble the chassis on page 8 .
2. Disconnect the motor plug from the control unit.
12 - Repair instructions
A
To assemble the
3. Remove the 2 screws that hold the gear housing
and motor in the chassis.
4. Remove the gear housing and motor from the
chassis.
5.6.2 To assemble the gear housing and motor in
the chassis
1. Put the gear housing and the motor in the left half of
the chassis. Make sure that the motor cables are put
in position (A) at the air holes in the chassis. Make
sure that the cables are put in the groove (B) above
the control unit.
A
B
B
B
580 - 001 - 27.03.2018