Gear, Cutting Unit And Gear Housing - RedMax BHT250PD60 Manual Del Usuario

CAUTION: Make sure that the cables do not
get damaged when the gear housing and
the motor are put on top.
2. Connect the gear housing and the motor in the
chassis with 2 screws.
3. Connect the plug from the motor to the control unit.
Attach the plug with the gray cable in position (C).
CAUTION: Make sure that the cables hang
straight down from the plug.
4. Assemble the right half of the chassis and the front
To remove the front handle on page 9
handle. See
To disassemble the chassis on page 8 .
and
580 - 001 - 27.03.2018
C

5.7 Gear, cutting unit and gear housing

5.7.1 To disassemble the gear, cutting unit and
motor out of the gear housing
1. Remove the 6 screws and remove the bottom plate
of the gear housing.
2. Remove the 2 screws and remove the gears and the
cutting unit from the gear housing.
Note: The front screw locks also the safety point with
the related nut.
Repair instructions - 13