Precautions; Results Of The Tests Carried Out According To The Laws; General Precautions; Use - CAMPAGNOLO STARBERRY MD1 Manual De Uso Y Mantenimiento

2.1

Precautions

WARNING!
The Manufacturer declines all responsibilities if the precautions below are not taken.
The accomplishments concerning working environment safety and health regulations indicated by the current
laws (2003/10/CE Directive, 2002/44/CE Directive and 81/2008 Law Decree) have to be carried out either by the end-
user or by the employer: supplying the adequate individual protecting devices, informing about working risks,
performing sanitary survey, etc...
The over-exposure to the vibrations may cause neurovascular lesions to people suffering from circulatory disor-
ders. In case of symptoms which could be referred to, such as an over-exposure, a specialist has to be contacted.
These symptoms can be torpor, loss of sensitivity, sharp pains, itch, strength reduction or loss, complexion dis-
coloration or structural modifications. This usually happens in one's hands, wrists and
2.1.1

Results of the tests carried out according to the Laws

WARNING!
Risks due to the operator's contact with the tool and/or machine noise and
Continuous A-weighted sound pressure level at the operator's ear (LpA), and sound power
1. SOUND LEVEL:
level of the tool (LwA), both calculated according to the UNI EN ISO
2. VIBRATIONS LEVEL:
to, measured in compliance with EN ISO 5349-2:
•
vibration level
3. ELECTROMAGNETIC COMPABILITY LEVEL
The equipment complies with the 2004/108/CE Directive and the following modifications.
2.2

General precautions

WARNING!
•
Use the tool only while standing on the ground in a safe and stable position.
•
Always use adequate clothing as called for by the job. Wear tight clothing. Do not wear ties, necklaces or belts
which may get caught in the moving parts. Use googles, safety shoes and antivibration gloves
•
It is compulsory to use a noise-abatement headset.
•
Do not operate, service or repair the equipment, if you are under the influence of alcohol or drugs, which could
impair your alertness or co-ordination.
•
Only well trained and qualified personnel, who have read this use and maintenance manual carefully, are allo-
wed to use the tool.
•
Keep children and animals away from the tool.
•
Do not alter the safety and protective devices.
•
The operator is the only responsible for injuries caused to other people or for damages caused to their belon-
gings.
•
Do not use the tool when you are in an unstable position or off balance.
•
It is forbidden to operate the tool while standing on a ladder.
•
Keep the moving parts away from your face.
•
Before any maintenance operations are carried out, switch the tool off. Disconnect the power supply cable (19)
from the battery (1).
•
Before any routine maintenance operation, carefully read this use and maintenance manual. For any other main-
tenance operation, which is not described in this manual, take the tool to an Authorised Service Point.
• The tool shall be used for the purposes described in par. "Product Description" only. Other uses could cause
injuries and/or damages.
•
Keep the tool in a dry place.
2.3

Use

•
Always wear goggles or a visor, safety shoes and antivibration gloves and a noise-abatement headset (fig. F).
•
The working position must be stable and safe.
• The tool shall be used only for the purposes described in par. "Product Description". Other uses could cause injuries
and/or damages.
•
When the Led light (9) is on, it indicates that the tool is working.
•
Do not open the tool body (21).
•
Do not leave the tool in the rain. Keep it in a dry place.
•
Do not carry the tool by the power supply cable (19).
Pag. 20
LpA eq = 73 dBA - LwA = 82 dBA
Average weighted hand-transmitted vibration value in frequency, the operator is exposed
vibrations.
3744:
s
a = 6,35 m/
heq
Use and Maintenance Manual – Original
Instructions Rev.: 02, Date 02/04/2020
fingers.