Energy RC-6C Manual Del Propietário página 4

5. Push the speaker up into the bezel, slipping the bezel's dog
screws through the large part of the speaker keyholes.
6. Twist the speaker (ceiling mount version) or slide the speaker
(wall mount version) so that the dog screw is positioned in the
small part of the speaker keyhole. Tighten the dog screws
until the speaker is tight against the bezel. Do not over
tighten. If the dog screws are too tight, the bezel will be
warped and the grille will not fit.
7. For ceiling models, orient the tweeter toward the listener.
Adjust the speaker settings as follows:
4
o w n e r s m a n u a l
You should utilize high quality speaker cables, up to 12 gauge
(AWG). The Reference Connoisseur Custom series will accept a
variety of connector types including banana jacks, or pin type
connectors. Audiophiles and novices alike have preferences as to
which connector type they favor, speak with your Authorized
ENERGY retailer as to which is the best for your Audio Video
System. Rest assured, plain speaker wire is more than acceptable,
you can always upgrade your wires and/or connectors later on.
To connect your speaker system: Start at one speaker, and
connect one channel at a time, starting with the front speakers.
Always ensure that the entire A/V system is powered OFF before
performing any connections. The positive and negative (red and
black) sides of the speaker terminals MUST match the positive and
negative (red and black) terminals of the receiver or amplifier. If
they do not match, abnormal sound and a lack of bass response
will result. After connecting the front speakers, connect the rest of
the speakers to their appropriate channels of the receiver or
amplifier. The three connection methods and their explanations
include: