Coffee flow - Advice on choice of coffee - Hot water jet
you wish to make) in the brass filter
holder (18).
30
•
Fit the filter holder into the coffee outlet
socket (7), pushing it upwards and turning
it to the right until it locks into place.
31
•
Place a cup under the filter holder.
To warm up the filter holder and the cup,
press the coffee switch (4); water will
begin to drip from the filter holder (this
operation is only necessary for the first
cup of coffee).
• When the cup is sufficiently full, press the
coffee switch (4) again.
32
•
Remove the filter holder from the
machine by turning it to the left.
29
•
To make one or two cups of coffee,
add 1 or 2 even measures of ground
coffee to the filter, depending on whether
you are using the single or twin cup filter.
• Tamp the coffee down using the lower part
of the coffee measure (15) and brush off
any excess coffee from the edge of the
filter holder.
30
•
Fit the brass filter holder (18) into
the coffee outlet socket (7), as explained
above, pushing it upwards and turning it
to the right until it locks into place.
31
•
Position two warmed cups under the
filter holder, making sure that they are
directly under the coffee spouts.
• Press the coffee switch. Wait until the cups
are sufficiently filled.
• Press the coffee switch again to stop the
coffee flow.
32
•
When the coffee flow has ceased,
remove the filter holder and empty out
the excess coffee grounds.
Cleaning hint: when cleaning the
i
filter take it right out of the filter
holder and rinse thoroughly.
6
ADVICE ON CHOICE OF
COFFEE
Practically any type of ground coffee on
the market can be used with this
machine.
Coffee is a natural product and its taste
varies, depending on its origin and
blend. It is therefore advisable to try a
number of different types to discover your
own personal preference.
For best results use blends specifically
ground for espresso machines.
The coffee flow should be constant and
should not drip.
The speed of the coffee flow can be
regulated by changing the dosage, the
fineness of the grinding and/or by how
heavily you tamp down the coffee in the
filter.
BEFORE USING THE HOT
WATER/STEAM JET, MAKE SURE
THAT
THE
("PANNARELLO") IS POSITIONED OVER
THE DRIP TRAY.
7
HOT WATER JET
Danger of burning! When water
begins to flow out, it may be
very hot. The steam tube does get very
hot, so avoid touching it in any way.
• If the machine is off, turn it on by the
main switch (3): the light (11) will go
on.
• Wait until the green machine-ready light
(12) goes on.
• Place a cup or a glass tea cup under the
steam tube ("Pannarello").
33
•
Open the "Hot water/steam knob
(6), turning it in anti-clockwise direction
and press the coffee switch (4) to start
the water flow.
• To stop the water flow, press the coffee
switch (4) again, and close the steam
25
STEAM
TUBE