Dash Disassembly - Metra 95-7622HG Instrucciones De Instalación

1. Unclip and remove the trim panel
on the end of the passenger side of
the dash. (Figure A)
2. Remove (1) Phillips screw securing
the A/C vent then unclip and
remove the vent. (Figure B)
3. Unclip and remove the trim panel
above the glove box starting at the
vent and working your way over to
the radio. Note: There is a hook
on the radio side of this panel
so make sure you start from
the vent on the passenger side.
(Figure C)
95-7622HG

Dash Disassembly

(Figure A)
(Figure B)
(Figure C)
4. Unclip and remove the A/C control.
(Figure D)
5. Unclip and remove the trim panel
to the left of the factory radio.
Note: On push to start models
this panel will have the start
button on it. (Figure E)
6. Remove (4) Phillips screws
securing the factory radio then
unclip and remove the radio.
(Figure F)
Continue to kit assembly
2
(Figure D)
(Figure E)
(Figure F)