Worx WG500 Manual Del Usuario página 10

ASSEMBLY
ASSEMBLING THE BLOWER/VACUUM
TUBE (Fig. A, B)
Before assembling the Blower/VacuumTube,
be sure the on/off switch (2) is in position ''O''.
Fit the Blower/VacuumTube to the motor
housing as shown in Fig. A and B. Check the
Blower/VacuumTube is firmly secured.
WARNING! Do not attempt to operate
or disable the safety switch by any
means other than the normal assembly or
removal of the cover.
NOTE: After assembling the Blower/Vacuum
Tube, you may disassemble the blower by
moving the On/Off switch (2) to position ''O''.
Then press the Release Button (3), so that you
can separate the tube. Do not try to separate
the tubes by force or by using tools.
ATTACHING THE DEBRIS COLLECTION
BAG (Fig. C)
The vacuum is equipped with a Debris
Collection Bag (10), which is designed for
collecting leaves and debris. Attach debris bag
as show in Fig C
10 10
–Align debris bag housing slots with the
locking pins
—push up into position, then rotate the debris
housing counter-clockwise
–ensure the debris bag is fully secured
OPERATION
CONNECTING TO A POWER SOURCE
Use only a polarized (i.e., one blade is wider
than the other), UL listed (CSA certified in
Canada) extension cord recommended for
outdoor use. A polarized plug will fit in a
polarized cord only one way. If the plug does
not fit fully in the cord, reverse the cord. If it
still does not fit, purchase a polarized extension
cord. Do not change the plug in any way.
Extension Cord
Length
100 ft.
150 ft
All-in-one Blower/Vac/Mulcher
Minimum Wire
Gage (A.W.G.)
14
12
NOTE: Do not use an extension cord over
150 feet.
If you do not fully seat the extension
cord on the inlet plug, the loose plug
could lead to overheating and cause a
fire, possibly burning you or others.
Ensure that you fully seat the cord on
the plug and use the cord lock feature to
secure the cord.
IMPORTANT: Check the power cord
frequently during use for holes in the
insulation. Do not use a damaged cord. Do not
run the cord through standing water or wet
grass.
STARTING/STOPPING (Fig. D)
IMPORTANT: The unit will not run unless
the Bower/Vacuum Tube is assembled to
the motor housing.
Starting
Connect the plug to the power outlet and
switch ON. Move the On/Off switch (2) to
position "I" .
Stopping
Move the On/Off switch (2) to position "O" .
WARNING! The tool runs for a few
seconds after it has been switched off.
Let the motor come to a complete standstill
before setting the tool down.
CONVERTING FROM BLOWER TO
VACUUM (Fig. E)
For selection of the operating mode, rotate
the Blower/vacuum selector lever (7) to the
required symbol (Fig E).
Blowing operating mode
Vacuum operating mode
USING THE BLOWER (Fig F)
The blower is intended for residential use
only. Use the blower outdoors to move debris
as needed.
CAUTION!
The blower can throw debris, possibly
causing serious personal injury to the
operator or bystanders.
EN