Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operating the extractor hood
The most effective method of removing
vapours produced during cooking is to:
❑ Switch the ventilator ON
as soon as you begin cooking.
❑ Switch the ventilator OFF
a few minutes after you have finished
cooking.
Switching on appliance:
L
+
Press the
or
button.
}
❑ The fan starts at Setting
.
Switching on the fan settings/intensive
setting:
1. To increase the fan settings or switch on
ç
the intensive setting
, press the
button.
❑ The intensive setting operates at
maximum power which should be
used only briefly.
If the intensive setting is not switched
off manually, the fan automatically
switches back to Setting
10 minutes.
2. To switch off the intensive setting
switch back to fan settings
switch off the extractor hood
–
completely, press the
button.
Fan – off –
Fan – on –
Fan settings
Fan settings
– lower –
– higher –
Light
on / off
Fan
Display:
on / off
❑ Fan settings / Intensive
ç
setting
Saturation – grease filter
❑
Saturation –
❑
activated carbon filter
Intermittent ventilation
❑ Used for ventilating the kitchen at hourly
intervals at the lowest fan setting, round
the clock.
Switching on appliance:
Press the
drawer.
❑ The fan runs for 5 minutes at Setting
then switches off for 55 minutes. This
process is repeated every hour.
Switching off:
Press the
Switching off:
There are 2 different ways of switching off
+
the appliance.
Switching off directly:
L
Press the
}
after
ç
or
~
}
|
and
–
–
Important: All fan functions are switched
off.
Switching off appliance with fan run-on:
Insert filter drawer all the way. The fans
operate in the last switched-on stage for
around another 10 minutes and then switch
off.
❑ When the extractor hood is switched off,
the operating mode and the fan setting
are saved. When the filter drawer is
pulled out, the extractor hood switches
Intermittent
on again at the saved settings.
ventilation
❑ If the intensive setting is switched on
when the filter drawer is inserted, the
intensive setting automatically switches
back during run-on.
#
❑ If intermittent ventilation is switched on, it
continues operating normally following
ã
run-on.
button and insert the filter
|
,
button.
button.
Light
❑ The light can be used at any time, even
when the appliance has been switched
off.
a
Switching on/off: Press the
Adjusting the brightness:
a
❑ Hold down the
button until the
desired brightness is obtained.
Filters and maintenance
Grease filters:
Metal-mesh filters are used to trap the
grease particles in the cooking vapours.
The filter mats are made from non-
combustible metal.
Caution:
As the filter becomes more and more satu-
rated with grease, there is an increased risk
of fire and the function of the extractor
hood may be impaired.
Important:
By cleaning the metal grease filters at
appropriate intervals, the possibility of them
catching fire as a result of a build-up of heat
such as occurs when deep-fat frying or
roasting is taking place, is reduced.
Saturation indicator:
When the grease filters reach saturation
point, an acoustic signal is sounded for 6
seconds after the fan has switched off, and
#
an
appears in the display. The grease
filters should be cleaned straight away.
Cleaning the metal-mesh grease filters:
❑ The filters can be cleaned in a
dishwasher. However, they may become
slightly discoloured.
Important:
Do not wash highly saturated metal-
mesh grease filters with other utensils.
❑ If cleaning the filters by hand, soak them in
a hot soap solution. Then brush the filters,
rinse thoroughly and leave to drain.
Clean the support frame for the grease
filters by hand.
button.
13
Publicidad
Tabla de contenido
