Publicidad
Step 15
Slide an ADJUSTABLE SHELF MOLDING* (M) onto the notched edge of the ADJUSTABLE SHELF (G).
å
Then, fasten a CARD HOLDER (35M) to the ADJUSTABLE SHELF MOLDING (M). Use two SILVER 1/2"
å
MACHINE SCREWS (38S).
Repeat this step for the other ADJUSTABLE SHELF (G).
å
*U.S. Patent No. 5,499,886
å
www.sauder.com/services
G
35M
Open end
M
Notched edge
These surfaces
should be even.
(2 used)
SILVER 1/2" MACHINE SCREW
(4 used for the CARD HOLDERS)
422596
Slide the ADJUSTABLE
SHELF MOLDING (M)
onto the notched edge.
M
38S
The groove
is closer to
this edge.
Page 19
Publicidad
