Adjusting Setup Items - Sony MEX-BT3050 Manual De Instrucciones

Adjusting setup items

1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until the desired
item appears, then press it.
3
Rotate the control dial to select the
setting, then press it.*
The setting is complete.
4
Press
* For CLOCK-ADJ, TUNER-STP and BTM
settings, step 4 is not necessary. And for BT
SIGNL and PAIRING settings, step 3 and 4 are
not necessary.
The following items can be set depending
on the source and setting:
CLOCK-ADJ (Clock Adjust) (page 5)
TUNER-STP (Tuner Step)*
CT (Clock Time)
Activates the CT function: "ON," "OFF"
(page 11).
BEEP
Activates the beep sound: "ON," "OFF."
CAUT ALM (Caution Alarm)*
Activates the caution alarm: "ON,"
"OFF" (page 5).
AUX-A (AUX Audio)*
Activates the AUX source display: "ON,"
"OFF" (page 23).
AUTO OFF
Shuts off automatically after a desired
time when the unit is turned off: "NO,"
"30S (Seconds)," "30M (Minutes)," "60M
(Minutes)."
REAR/SUB*
1
Switches the audio output: "REAR-
OUT" (power amplifier), "SUB-OUT"
(subwoofer).
22
(BACK).
(page 4)
1
1
2
BLK OUT (Black Out)
Turns off the illumination automatically
for any source (e.g., during radio
reception/CD playback, etc.) if no
operation is performed for 5 seconds:
"ON," "OFF."
To bring the light back on, press any
button.
DEMO (Demonstration)
Activates the demonstration: "ON,"
"OFF."
DIMMER
Changes the display brightness: "ON,"
"OFF."
AUTO SCR (Auto Scroll)
Scrolls long items automatically: "ON,"
"OFF."
LPF (Low Pass Filter)*
Selects the subwoofer cut-off frequency:
"OFF," "80Hz," "100Hz," "120Hz,"
"140Hz," "160Hz."
SW PHASE (Subwoofer Phase)*
Selects the subwoofer phase: "SUB
NORM," "SUB REV."
HPF (High Pass Filter)
Selects the front/rear speaker cut-off
frequency: "OFF," "80Hz," "100Hz,"
"120Hz," "140Hz," "160Hz."
LOUDNESS
Reinforces bass and treble for clear
sound at low volume levels: "ON,"
"OFF."
BTM (Best Tuning Memory) (page 10)
BT INIT (Bluetooth Initialize)*
BT SIGNL (Bluetooth Signal)
Turns the Bluetooth signal on/off.
PAIRING
Turns the pairing mode on/off.
Memorizes the information between this
unit and the Bluetooth device.
2
2
(page 19)
1