Vortice MG Folleto De Instrucciones página 10

ENGLISH
or suffer a heavy blow, have it
checked immediately by a
qualified engineer.
• In case of poor exhaust unit
performance or malfunction,
immediately contact a Vortice
Service Centre. If any parts need
replacing, request the use of
original Vortice spare parts.
• If the appliance is to be removed,
turn the switch to off and then
disconnect the unit from the
mains.
Do not leave the appliance in
reach of children.
• The appliance is not intended for
use by young children or infirm
persons without supervision.
• Young children should be
supervised to ensure that they do
not play with the appliance.
• The appliance must not be used
to activate water heaters, stoves,
etc., nor must it extract to their
hot-air conduits.
• For the electrical connection, use
The power-source data must be
consistent with the electrical
data shown on the name plate A.
a bipolar cable with 0.5 mm
conductor sections. For the timer
version, a three-pole cable must
be used with 0.5 mm
sections. In the three cables, you
must not use the color
yellow/green because it is
reserved for the ground.
• In the event the product is
installed in a vertical tube, it is
necessary to interpose the anti-
condensation trap (fig. 14).
• The product must be cleaned at
least every 6 months by a qualified
person. Before carrying out
cleaning or mainenance
operations, please disconnect the
product from the electric supply
mains.
N.B.
In the event the exhaust fan is
mounted at a height of less than
2.3 meters, the fixed protection
grill must be attached (fig. 12).
10
2
2 conductor