Remote Control - Zanussi ZFG816X Manual De Instrucciones

It is recommended to leave the hood
operating for approximately 15 minutes
after cooking.
To operate the hood:
1. Press the first speed button
the appliance.
2. If needed, press the light button
illuminate the cooking surface.
3. If needed, change the speed by pressing the
desired button.
To turn off the appliance press the first speed
button again.
HOB²HOOD FUNCTION
It is an automatic function which connects the hob
with a hood. Both the hob and the hood have an
infrared signal communicator. Speed of the fan is
defined automatically on basis of mode setting and
temperature of the hottest cookware on the hob.
You can also operate the fan using the hob
manually. The function can be activated from panel
of the hob.
For more information how to use the
function refer to the hob user manual.
FILTER NOTIFICATION
Filter alarm reminds to change or clean the charcoal
filter and clean the grease filter. The filter indicator
is turned on for 30 seconds if the grease filter
must be cleaned. The filter indicator
While heating up food, cooking with covered pots.
While cooking with covered pots on multiple cooking zones
or burners, gentle frying.
While boiling, frying big quantities of food without a lid,
cooking on multiple cooking zones or burners.
While boiling, frying big quantities of food without a lid, big
humidity. The hood operates on maximum speed. After 6
minutes the appliance returns to previous setting.
to switch on
to
flashes for
30 seconds if the charcoal filter must be replaced
or cleaned.
Refer to cleaning the grease filter in
care and cleaning chapter.
Refer to cleaning the charcoal filter or
replacing the charcoal filter in care and
cleaning chapter.
To reset the function press the button
seconds.
To activate or deactivate function:
1. To activate function press the button
seconds.
If the function is activated, the indicator
two times.
2. To deactivate function press the button
3 seconds.
If the function is deactivated, the indicator
flashes ones.
REMOTE-CONTROL
The appliance can be controlled with a remote-
control. Visit local supplier to buy the remote-
control.
The connection is originally enabled.
To connect or disconnect remote-control:
1. Switch off the appliance.
2. Press the for 3 seconds.
The indicator on control panel flashes twice if
function is enabled and once if disabled.
for 3
for 3
flashes
for
23