Control Panel - Zanussi ZHC4284 Manual De Instrucciones

The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam.
The appliance can be installed to recirculate or extract contaminated air.

Control Panel

L
Button Led
L -
T1 Fixed
T2 Fixed
T3 Fixed
T4 Fixed
S1 Fixed
Flashing
GB
OPERATING INSTRUCTIONS
T1
Function
Turns the lights on/off at maximum strength.
Turns the motor on/off at speed one.
Turns the Motor on at speed two..
Press and hold the button for approximately 3 seconds, with all the loads tur-
ned off (Motor and Lights), to turn the Activated Charcoal Filter alarm on. The
To turn the alarm off, press the button again and hold for at least 3 seconds.
Turns the Motor on at speed three..
Press and hold the button for approximately 3 seconds, with all the loads tur-
ned off (Motor and Lights), to perform a reset of Filter saturation alarm.
The LED S1
Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 6 minutes.
At the end of this time, the system returns automatically to the speed that was
set before.
If it is activated with the motor turned off, the hood will switch to OFF at the end
of the time.
Press and hold for 3 seconds to enable the remote control, indicated by the
Press and hold for 3 seconds to disable the remote control, indicated by the
Signals the Metal Grease Filter saturation alarm, indicating that it is necessary
When this is activated, it signals the Activated Charcoal Filter saturation alarm,
washed.
The Activated Charcoal Filter saturation alarm comes into operation after the
T2 T3
S1
T4
8