Peavey PV 115 D Manual De Instrucciones página 25

All manuals and user guides at all-guides.com
PEAVEY PV 115D - SPECIFICATIONS
® ®
Frequency Range: 1 meter on-axis, swept-sine in 1/2 Space
environment, -10 dB: 46 Hz to 21 kHz
Frequency Response: 1 meter on-axis, swept-sine in 1/2 Space
environment 66 Hz to 17 kHz (± 3 dB)
Sensitivity (1w/1m): 95 dB
Maximum Peak SPL: 121 dB
Transducer Compliment: Transducer Compliment: Heavy-duty 15"
woofer with 2 3/8" voice coil & 50 oz. magnet. RX
diaphragm dynamic compression driver, on a Constant Directivity 60
X 40 horn.
Nominal Coverage Pattern: 60 degrees horizontal by 40 degrees
vertical
Electro-acoustic Crossover Frequency: 3 kHz
Input Connections: One combo female XLR/ 1/4" phone jack
providing balanced or unbalanced operation.
Enclosure Materials & Finish: Trapezoidal, black carpet covered
12mm MDF, black powder-coated full length perforated steel grille.
Mounting or Suspension: Steel 1 3/8" pole-mount cup for stand
mounting, four rubber feet for floor use.
NOTE: This unit is not designed for overhead suspension!
Dimensions (H x W x D):
32.25 in. x 18.83 in. x 14.75 in.
Front:
819 mm x 478 mm x 375 mm
Rear: 32.25 in. x 11.25 in. x 14.75 in.
819 mm x 286 mm x 375 mm
Weight:
56 Lbs. (25.4 kg)
ELECTRONICS AND AMPLIFIER SPECIFICATIONS:
Power Amp Rating, Total Power Output: 800 watts peak available
power, Continuous Power: 400 watts into 4 ohms @ less than 1%
distortion
Electronic Input Impedance (Nominal): 2.7 k ohms balanced (XLR or
1/4"), 1.35 k ohms unbalanced 1/4".
Infrasonic filter protection: 24 dB/octave roll-off
™
14 1.4" titanium Nominal Amplifier Frequency Response: +0, -3 dB from 20 Hz to 20 kHz
Hum and Noise: Greater than 90 dB below rated power
DDT Dynamic Range: Greater than 14 dB
THD and IM: Typically less than 0.5 %
Damping Factor: Greater than 400 @ 1000 Hz, 8 Ohms
Power requirements of Peavey PV
Watts, Voltage and Frequency Ranges: 100-120 VAC, and 220 –
240VAC, at 50- 60 Hz
Fuse Type:
For 100-120 VAC USE: International fuse classification T6.3AL . In
the USA, types GDC, GMC, 215, 218, and 477 cartridge-style 5 x 20
mm size fuses with a 6.3 amp 250V rating can be used.
For 220-240 VAC USE: International fuse classification T3.15AL .
This is a cartridge style 5 x 20 mm size time-delay fuse with a 3.15
amp 250V rating.
®
115D System: Nominal 370