Design Information; Product Dimensions And Clearances - Cafe C2Y366 Instrucciones De Instalación

PRODUCT DIMENSIONS AND CLEARANCES

48" Range Models
Width
Front of Bullnose
Height to trim.
Trim to be flush
or higher than
countertop.
to Front of Door
WARNING
Installations without a
hood require 48" minimum to combustibles.
horizontal combustible surfaces must have
an Auto-On feature. Refer to hood installation
instructions for specific hood clearances.
The surface of the entire back wall above
the range and below the hood must be
covered with a non-combustible material
other stone.
CAUTION
To prevent drafts from
in floor under appliance and behind
appliance wall.
** As defined in the National Fuel Gas Code (ANSI
from non-combustible materials are not part of the
CSA. Clearances less than 12" must be approved by
ADDITIONAL CLEARANCES:
Allow 12" minimum clearance to an adjacent wall on
each side.
Working areas adjacent to the rangetop should have
18" minimum clearance between countertop and the
bottom of the wall cabinet.
cutout to back edge of countertop and 3 in. minimum
from cutout to side edges of countertop (see top view).
4

Design Information

1" Countertop
to Cooking
Surface
leg Height
16"
Universal Utility Locations
8"
14"
Electric
48"
Minimum
48"
Minimum to
Combustible
Non-
Combustible
Material **
12"
Minimum
Each Side
48" Min.
Back
3" Min.
Island
Cutout
Top View
16"
Electric
2"
2"
48"
12" Minimum
to Adjacent Wall
18"
Min.
3" Min.
31-2000815 Rev. 0