Do not add accessories or equipment to your bicycle yourself and do not
at+empt to modify it. For any accessories (mudguards, lights, ...), always
choose quality components by consulting a specialist dealer.
At0ention
When tightening the screws follow the torque instruction indicated on
the equipment itself or refer to the "Torque char+" table in this
manual.
Bat0ery
Bat0ery removal and installation
TK01 models
The first thing necessary to do is to remove the bat+er cover by
unscrewing the two socket head screws (2.5 mm wrench) on the bot+om of
the cover.
Then inser+ a 4 mm wrench in the specific socket head screw and turn it
clockwise one-four+h of a turn to make the bat+ery come down. At this
point, press the chrome-plated tab downwards with your finger in order to
completely remove the bat+ery.
39
To install the bat+ery: match the protrusion of the
bot+om suppor+ with the groove found on the
bot+om of the bat+ery and, while pivoting on the
lower base, accompany the upper par+ of the
bat+ery inside the frame.
Push the two tabs of the bat+ery cover into their
grooves and screw the two socket head screws back
on.
MIG models
For the bat+ery cover with quick release: unscrew the fixing screw and
remove the cover itself. Inser+ and turn the key in the pawl, then rotate
the bat+ery outwards (right side).
40