Setup Menu; Setting The Default Option - Metria M21 Manual De Instrucciones

6

Setup Menu

Setup Menu
The METRIA M21 pH meter contains an integrated setup menu that is used to customize the displayed option to meet
measurement requirement. The following table describes the functions of each menu item.
Menu Description
Set the pH buffer group for calibration and auto-
recognition.
Set the number of calibration points.
Set the default temperature unit.
When the option is enabled, the meter will
automatically
sense a stable reading and lock the measurement.
When the option is enabled, the meter will
automatically
switch off if no key is pressed within 3 hours.
Reset the meter to factory default settings.

Setting the default option

1. Press and hold the
Press the  /  key to select an option, press the Enter key to confirm and switch to the next menu item.
2.
3. Repeat the steps above until the meter returns to the measurement mode.
Menu item
key for 3 seconds to enter the setup menu.
Options Description
USA
(pH4.01/7.00/10.01)
NIST
(pH4.01/6.86/9.18)
1 point
2 points
3 points
Degrees Celsius
Degrees Fahrenheit
Enable
Disable
Enable
Disable
Enable
Disable
Option
Default
USA
3 points
°C
Disable
Disable
Disable