Solutions To Common Problems - IKEA KONSISTENS Manual De Instrucciones

Ocultar thumbs Ver también para KONSISTENS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN

Solutions to Common problems

Before you call for service, review the following list. It may save you time and expense. Possible solutions
are provided with the problem listed
problem
Entire appliance does not
operate
problem
Oven control panel beeps
and displays error codes
Poor baking results.
Appliance is not level
Cannot move appliance
easily
Appliance must be acces-
sible for service
Appliance does not oper-
ate
Cause / Solution
Appliance not connected. Make sure power cord is plugged properly into out-
let. Check your fuse box or breaker box to make sure the circuit is active.
Electrical power outage. Check house lights to be sure. Call your local electric
company for service outage information.
Cause / Solution
Oven control has detected a fault or error condition.
When this occurs an E or F will show in the display.
Press OFF: Activate a Bake or Broil.
If the F or E code error repeats, turn off power to appliance, wait 5 minutes
and then repower appliance. Set clock with correct time of day.
Try Bake or Broil function again. If a fault code appear again, press OFF to
clear the error code and contact your servicer.
Many factors effect baking results.
Use proper oven rack position.
Center food in the oven and space pans to allow air to circulate.
Preheat oven to the set temperature before placing food in the oven.
Try adjusting the recipe's recommended temperature or baking time. See
"Adjusting Oven Temperatures" on page 22 if you feel the oven is too hot or
cold.
Poor installation. Place oven rack in center of oven. Place a level on the oven
rack to check if oven has been properly installed.
Kitchen cabinet alignment may make oven appear not level. Be sure cabinets
are square and have sufficient room for appliance clearance.
If cabinets are not square or are built in too tightly, contact builder or install-
er to make appliance accessible.
Cabinets not square or are built in too tightly.
Contact builder or installer to make appliance accessible.
Electrical power outage. Check house lights to be sure.
Call your local electric company for service outage information.
Service wiring is incomplete. Call
BEFOrE yOU CaLL
(
833) 337-4006 for assistance.
29

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido