Changing Blades - Marshalltown Bullet BT92-2012 Manual De Instrucciones

CHANGING BLADES

CAUTION
! BLADES ARE VERY SHARP !
C
Blade Cartridge
USE EXTREME CAUTION
E
CHANGING THE UPPER BLADE
1. Pull sideways on the blade receiver assembly (A) until it
D
snaps out of position, then press down to remove it from
the Cruiser frame.
E
2. Extend the blade cartridge fully by turning the blade
adjustment knob (B) clockwise until it stops. Do not force
B
the knob further.
3. Use a pen or small screwdriver to push the axle pin (C)
out of the blade cartridge.
A
4. Slide the blade (D) and spacers (E) out of the blade
cartridge.
5. Discard the old blade and place a new one onto the axle
pin, (C) sandwiched between the two spacers.
6. Apply a film of grease to the small steps on the sides of
the spacers (E) and to the axle pin (C).
7. Slide the blade and spacers back into the blade
cartridge and center the axle pin.
8. Reinstall cartridge, snap blade receiver assembly (A)
back into position.
CHANGING THE LOWER BLADE
1. Turn your Cruiser upside-down. Remove the hairpin
cotter (F) from the driveshaft coupler (G).
F
2. Slide the driveshaft coupler (G) to remove the
connected axle from the drive wheels (H) and blade (J).
G
J
3. Remove the drive wheels (H) and blade (J) and pull apart
to remove the old blade.
H
4. Insert new blade and follow the first three steps in
reverse to reinstall.
View when Cruiser is
CRUISER REPLACEMENT BLADES
upside-down
Upper Blade (L): 2095B
Lower Blade (K): 2012B
K L
7 of 12
WS2641
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com