Publicidad
Idiomas disponibles
Idiomas disponibles
3. Attaching Side Kits to a Surface Mounted Cabinet
1. Apply foam tape to Side kit bracket
A. Peel tape from sheet, leave liner on.
B. Apply as shown to side kit brackets, be sure they are clean and dry.
C. DO NOT PEEL RELEASE LINER UNTIL YOU HAVE TEST FIT THE
SIDE KITS ON THE CABINET!
2. Attach the side kit brackets to the cabinet as shown in Fig. 5
3. Test fit the side kits, then clean the back of the side kits with rubbing alcohol.
4. Peel the release tape from the brackets and apply the side kits, push firmly
to set.
5. Cover the screw heads with the screw caps.
Fig. 5
Align top of side kit with top of flange
Side kit bracket
(Fits tight under the
flange of cabinet)
#8 x 3/8" screws
self thread into
Side Kit brackets
Side Kit brackets
6-32 x 3/8"
(SS679)
2 pieces
26" high
4. Door adjustments
A. This screw releases the
door from the cabinet and
allows up and down
adjustment.
8-32 x 1/2" (SS829)
B. These screws allow you to plumb
the door as shown in Figure 6.
Fig.6
209-1019 Devonshire Cabinet
Publicidad
