Switching On The M260Se Handheld Terminal; Suspend Mode - ACD SetM260SEHF Manual Del Usuario

3.2.5 Switching on the M260SE Handheld Terminal

In order to switch on the device, press the "C" button and the "orange enter" button to the right of "0"
simultaneously until the LED beneath it lights up. You can then release the buttons. The desktop of your
operating system or your usual work environment appears on the display.
You can see the buttons, you have to press to switch on the device as shown in Figure 6.
Figure 6: Switching on the M260SE

3.2.6 Suspend Mode

In suspend mode, the operating system and the application running on it are stopped. The display is
switched off and consequently becomes dark. Suspend mode can be accessed by simultaneously pressing
the "C" button and the "orange enter" button to the right of "0". Upon leaving suspend mode (switching on the
M260SE), the application and the operating system starts to run from the same point. Thanks to both
measures, the M260SE only uses a small amount of power.
Figure 7: Suspend Mode of the M260SE
M260SE_Brief_Overview_FCC_PEPPERL+FUCHS_V1.03_en_es.docx 10 / 28